[initeq] 3-Pack 2M (2 Meters) Stepper Motor Cable for 3D Printer and NEMA 17 Stepper Motors – JST Connector

2M (2 Meter, approximately 6.5 ft.) stepper motor cable6-pin JST connector commonly used on the stepper motors found on 3D Printers on motor end4-pin JST connector on the other (this connector is commonly found on 3D printer control boards, but differs from the also-popular Dupont connector). 2M length enables flexibility in mounting locations for control boards (outside of heated enclosures) and remote bowden extruders. Specifications: Length: 2M (2 meters, approx. 6.5 ft.) Wire Gauge: 26 AWG Please verify that the pinout of your driver/controller and motor match the pattern of these cables. Some configurations do not require the "crossover", in which case this cable should still work after simply removing 3 pins from one end of the connector by depressing the tab on the metal pin with a small pointed tool while carefully pulling the wire (one at a time), and then re-inserting the wires in the desired order (after bending the tab back out slightly so that the pins will lock into the connectors). We are happy to work with you to help resolve any potential pinout issues. These cables work with the most common pinouts we have encountered, but not all. Thankfully reconfiguring the cable is very easy.

• 3 Pack
• 6-Pin JST connector on motor end
• 4-Pin JST connector on controller end
• Extra-long 2M length (over 6.5ft)
• Easy to re-pin should a different pinout be required for your motor/driver combo